Products

Your current location：

Home page

Industry Application

Contat Us

Tel：13825261709

E-mail：mtbjzj@163.com

Website：www.mtbjzj.com

Address: 3rd Floor, Building B, Nanlian Hengyu Science Park, No.1 Ruiji Road, Longgang District, Shenzhen

Crafts

MTB-2209 UV Stable Crystal Clear Table Top System is a high performance two component Clear epoxy system designed for Table Tops, Bars, Wood finishes, See-Through Encapsulations, Artwork, and other applications requiring a clear, strong, plastic coating specifically designed to resist Yellowing caused by the sun and other Ultra Violet light sources. The material has an easy to use 1 to 1 by volume mix ratio, maintains its integrity over sharp corners, and it has excellent air release qualities and a relatively fast set time for an epoxy coating. Features&Advantages100% Solids,Non-toxic,Voc Free Solvent Free Self Leveling, High Gloss with ultra-clear finishU.V. Resistant FormulaExcellent Air ReleaseExcellent Color StabilityImproved Impact StrengthImproved Surface AppearanceEarly Development of Physical and Performance Properties Produces a Tough, High Gloss, Water Resistant Coating Eliminates Craters, Crawling and Fish Eyes Blush ResistantSeal Coat StageThe seal coat is designed to penetrate and cover a porous surface. Some very aged and kiln dried porous woods (old barr wood, knotty wood, wood with cracks and holes) may need multiple seal coats to prevent air from escaping them and creating bubbles in the fiood coat. It is not uncommon for as many as 3 seal coats to be used on aged and kiln dried woods. Flood Coat StageEach flood coat self-levels at approximately 1/8" thick. If depths thicker than 1/8" are desired multiple coats are necessary. Bar Rails and EdgesThe filood coat can be allowed to run over the sides which will create a coating on the vertical edges. These vertical edges will not be as thick as the top surfaces so you must do your best with a brush to keep the material even. Underneath EdgeDrips will form underneath the bar-rail or edge,these drips can be sanded off once the epoxy has cured. If you catch the epoxy at just the right moment in the curing process cut or scrape the drips off as they will still be soft.